ROAD BLOCKER

First of all, before starting the assembly, the correct product must be selected in the correct dimensions. The height standard may be around 50/60 cm, but in places where very high security is required, the height can be increased up to 100 cm.

In terms of width, the positions of the doors used and the road passage widths are important. If entry and exit are made through the same door, the product width can be used variably between 2 and 5 meters.

On the application side, the area to be applied must be excavated with a work machine. Since the product is a boiler type product buried in the ground, the dimensions of the area to be excavated must be according to the dimensions of the product.

In order for the product to be used against water for many years without rotting, it is recommended to use either a submersible pump type pump or a drain structure connected to the water drain in the excavation area. If there is no water drain or there is no area where the excess water from the pump will be poured when using the pump, the lower ground part of the product is covered with gravel. For example, half a meter high gravel is filled on the ground and the product is placed on it. Thus, a ground is created for the rainwater to absorb the water of the soil at the bottom, but this method increases the possibility of the product to rot and is not recommended.

It is recommended to place red-green lights and informative traffic lights on the entrance and exit sides of the product. At the same time, a loop detector, which we call a vehicle-detecting metal mass detector, or mutually visible photocells should be used in front and behind the product. When a vehicle approaches the road blocker, if the product rises up, the vehicle on top of it should be used. It should be ensured that these sensors do not detect the vehicle in advance and initiate the lifting process, as this will cause damage and lift the vehicle up.